Made a bunch of 3/4in and 1in plugs last week but just made a 2in pictured. It is a thing that does not exist, which seems silly obvious. This goes in the concrete just below the surface so they can polish it before these plugs are broken out with a hammer and wire gets ran.
Made a series of TPU plugs for electrical conduit getting embedded in concrete foundations.
Made a series of TPU plugs for electrical conduit getting embedded in concrete foundations.
Made a bunch of 3/4in and 1in plugs last week but just made a 2in pictured. It is a thing that does not exist, which seems silly obvious. This goes in the concrete just below the surface so they can polish it before these plugs are broken out with a hammer and wire gets ran.
Any ideas why my layers are lifting while printing?
Eventually the nozzle snags and th while print pulls off the bed. I can't figure out what is happening
PCB Workstation Kit using acupuncture needle probes
https://www.thingiverse.com/thing:5881008 ...
Ouroboro – Closed Loop TMC4671 Stepper/Servo Field Oriented Control FOC driver board for Klipper/Voron ( www.youtube.com )
From independent, open source hardware developer Isik's Tech in the USA. Dual motor driver, demonstrates 250k open loop accelerations. $350 ...