Metal Stand Blueprint for asics?

[tvsm22]

Hellow. I want to make a metal stand for my asics and maybe someone have some kind of a blueprint, or simple drafts of such a stand?
Want to make good looking and usefull. Please help 
Have all the needed equipment to make from metal - rolling, cutting, even painting oven :-)

[jackg]

You might want to move this to the mining board to get more of an input for what active miners are using - the move button is at the bottom left.

I've seen a lot of people use just normal shelving units you can find in most places (like the ones shops use) but a lot of them seem to have slats in them to allow for better air flow.

[BitMaxz]

I couldn't find any blueprint but why not make simple as this design below?

You can use this as your reference.


Then look at this

[crwth]

Why not use a good dissipater of heat? Probably not fully metal frame but a ceramic tabletop that could have better thermal conductivity and can resist high temperature that could damage the table in the long run.

I don't think you need a special blueprint, just possibly a plan on how you will set up your Asics and how many will be placed on a single layer, etc. Reverse engineer it and then make the necessary measurements.